BPS 9" Driveshaft Sensor Bracket

A driveshaft speed sensor is only as good as what it's bolted to. Mount it on something that moves and the signal picks up vibration, and you end up chasing data that was never real.

This bracket mounts your sensor to a 9 inch centre section off the housing itself. Cut from 0.125 inch stainless, thick enough that it isn't resonating at track RPM.

Available for 3/8 inch or 12mm sensor bodies — check which one you have before ordering, they are not interchangeable.

Features:

• 0.125 in thick stainless steel
• Mounts to a 9 in centre section
• Sized for 3/8 in or 12mm sensors
• Rigid mounting for clean data

Sensor not included.

BPS part numbers: LC003-38 (3/8 in), LC003-12 (12mm)

The other half of a data setup on a leaf or four link car is shock travel: our shock sensor brackets (LC011) mount the top and bottom travel sensors as a pair. What the numbers are for, and where we start on anti-squat by power level: anti-squat explained.